Telco RJ21 Cable to RJ45 PatchPanel 19" 1U 24 ports RJ-45 signs 4 y 5 with RJ21 180 degrees end
-3 Item Items
Warning: Last items in stock!
|Cable type||Telco /RJ21|
Telco RJ21 cable solution to RJ45 Patch Panel 19" 1U 24 ports RJ-45 signs 4 y 5 configuration. Cable ended in 180 degrees Telco connector for gateway connection.
A telco cable, also known as a Telecom cable or Amphenol cable, is a thick cable used for connecting multiple voice or data lines for LANs or telecommunications. The ends use 25 pairs of polarized pins (50 pins total). This cable handles up to 25 data channels or phone lines. The name Amphenol comes from the company that first manufactured it.
Most phone systems use this type of cable. The common color is gray and made of polyvinyl chloride (PVC). Most manufactures have standardized on this color for this material. Another standardized color is white, usually associated with plenum cable. Plenum cable is cable used in plenum spaces of buildings. The plenum is the space used for air circulation for heating and air conditioning systems, by providing a location for ductwork. Space between the structural ceiling and the dropped ceiling or under a raised floor is typically considered plenum. Some drop ceiling designs create a tight seal that does not allow for airflow and therefore may not be considered a plenum air-handling space.
The telco cable is also associated with pre-wired 66 blocks pre-assembled with an RJ-21 female connector are available that accept a quick connection to a 25-pair cable with a male end. These connections are typically made between the block and the CPE (customer premises equipment).
RJ-21 is a registered standard RJ family, works with a modular connector can be used up to 50 drivers, is usually used to implement a connection of 25 lines (or less) as it is used in the model of phone system called 1A2 key.
It is also known as the telecommunications connector 50-pin. Sometimes dual RJ21 blocks are used to strike out and make a phone booth for PBX and other telephone systems.
The RJ21 connectors are used to connect Ethernet ports massively from a switch with RJ21 ports to a patch panel UTP cable category 5 or connection between two panels.
A cable with an RJ21 connector can support 6 modular connectors 8P8C to its maximum capacity of drivers.
All of these registered jacks are described as containing a number of potential contact positions and the actual number of contacts installed within these positions. RJ11, RJ14, and RJ25 all use the same six-position modular connector, thus are physically identical except for the different number of contacts (two, four and six respectively) allowing connections for one, two, or three telephone lines respectively.
Cords connecting to an RJ11 interface require a 6P2C connector. Nevertheless, cords sold as RJ11 often use 6P4C connectors (six position, four conductor) with four wires. Two of the six possible contact positions connect tip and ring, and the other two conductors are unused.
The conductors other than the two central tip and ring conductors are in practice variously used for a second or third telephone line, a ground for selective ringers, low-voltage power for a dial light, or for anti-tinkle circuitry to prevent pulse dialing phones from sounding the bell on other extensions.
We have several configurarions and lengths available. If you do not find what you need please contact us. We can manufacture for you.